Add any MAC addresses that begin with 02:0F:B5 into your router's MAC filter table. Log in to your router and check the attached devices on the Attached Devices screen.Make sure that the Link Rate LED remains lit.Power on the EX6100 and connect all of your wireless devices to the EX6100.To allow this wireless device to access the Internet, you must add the translated MAC address into the router. If your router MAC filter is enabled, the wireless device will not be able to get the IP address from the EX6100. The wireless device MAC address is translated to another MAC address when the wireless device connects to the EX6100. What should I do when installing the EX6100? I have enabled a wireless MAC filter (wireless access control – ACL) on my router. Since the EX6100 provides 1x1 11ac antenna stream in 5GHz band the connection in 5GHz band will be the lower of the two, meaning 1x1 11ac. My 5GHz client becomes slower when connected to the EX6100 than directly connected to my 3x3 router? The new and most up-to-date firmware will likely correct issues as well as potentially add new and improved features to the product. Having the latest firmware will help increase the stability, functionality and performance of your product. Why do I need to always have the latest firmware on my NETGEAR product?
